How To Jumpstart A Dodge Avenger

If your vehicle has a discharged battery it tin exist jumpstartedusing a set of jumper cables and a bombardment inanother vehicle or by using a portable battery boosterpack. Jump-starting can be unsafe if washed improperlyso please follow the procedures in this section carefully.

Notation: When using a portable battery booster packfollow the manufacturer's operating instructions andprecautions.

Caution:

Do not use a portable bombardment booster pack or anyother booster source with a system voltage greaterthan 12 Volts or impairment to the battery, starter motor,alternator or electric organisation may occur.

WARNING:

Do not effort jump-starting if the battery is frozen.

It could rupture or explode and cause personal injury.

Preparations for Leap-Offset

The bombardment in your vehicle is located between the leftfront headlight assembly and the left front bike splashshield. To allow spring-starting there are remote batteryposts located on the left side of the engine compartment.

Remote Battery Posts

1 — Remote Positive (+) Post (covered with protective cap).

ii — Remote Negative (-) Postal service.

Warning:

• Take care to avoid the radiator cooling fan wheneverthe hood is raised. It can commencement anytime theignition switch is on. Y'all can be injured bymoving fan blades.

• Remove any metallic jewelry such as sentry bands orbracelets that might make an inadvertent electricalcontact. Yous could be seriously injured.

• Batteries incorporate sulfuric acid that can burn yourskin or eyes and generate hydrogen gas which isflammable and explosive. Keep open flames orsparks away from the battery.

1. Ready the parking restriction, shift the automatic transmissioninto PARK and plow the ignition to LOCK.

2. Turn off the heater, radio, and all unnecessary electricalaccessories.

three. Remove the protective comprehend over the remote positive(+) bombardment mail. To remove the cover, press the lockingtab and pull upward on the cover.

Locking Tab

4. If using some other vehicle to spring-start the bombardment, parkthe vehicle inside the jumper cables achieve, ready theparking restriction and make certain the ignition is OFF.

WARNING:

Do not allow vehicles to touch each other as thiscould establish a basis connexion and personalinjury could result.

Jump-Starting Procedure

WARNING:

Failure to follow this process could result in personalinjury or property damage due to battery explosion.

Circumspection:

Failure to follow these procedures could effect indamage to the charging organisation of the booster vehicleor the discharged vehicle.

i. Connect the positive (+) end of the jumper cablevision to theremote positive (+) post of the discharged vehicle.

2. Connect the contrary end of the positive (+) jumpercable to the positive (+) post of the booster battery.

iii. Connect the negative finish (-) of the jumper cablevision to thenegative (-) postal service of the booster battery.

4. Connect the opposite end of the negative (-) jumpercable to the remote negative (-) post of the vehicle withthe discharged bombardment.

WARNING:

Do non connect the cablevision to the negative post (-) of thedischarged battery. The resulting electric sparkcould cause the battery to explode and could consequence inpersonal injury.

5. Offset the engine in the vehicle that has the boosterbattery, let the engine idle a few minutes, and and so startthe engine in the vehicle with the discharged bombardment.

One time the engine is started, remove the jumper cables inthe contrary sequence:

6. Disconnect the negative (-) jumper cable from theremote negative (-) postal service of the vehicle with the dischargedbattery.

7. Disconnect the negative finish (-) of the jumper cablefrom the negative (-) post of the booster battery.

8. Disconnect the contrary cease of the positive (+) jumpercable from the positive (+) post of the booster bombardment.

nine. Disconnect the positive (+) end of the jumper cablefrom the remote positive (+) post of the dischargedvehicle.

ten. Reinstall the protective embrace over the remote positive(+) bombardment post of the discharged vehicle.

If frequent spring-starting is required to starting time your vehicleyou should have the battery and charging system inspectedat your authorized dealer.

Circumspection:

Accessories that tin can be plugged into the vehiclepower outlets depict power from the vehicle'due south bombardment,even when not in utilise (i.due east., cellular phones, etc.).

Eventually, if plugged in long plenty, the vehicle'sbattery will discharge sufficiently to degrade batterylife and/or foreclose the engine from starting.

Jacking and tire irresolute

WARNING: • Being under a jacked-upward vehicle is unsafe. Thevehicle could sideslip off the jack and fall on y'all. Youcould exist crushed. Never put whatever part of your bodyunder a vehicle that is on a jac ...

Freeing a stuck vehicle

If your vehicle becomes stuck in mud, sand, or snow, itcan often be moved by a rocking motility. Turn yoursteering wheel correct and left to clear the area effectually thefront wheels. So shift back and ...

See also:

Comparison with ordinary remote control
The functions tin be controlled past pressing the buttons of the remote command or Condolement Admission. Unlocking Fully grasp a door handle, arrow 1. This corresponds to pressing the button. Lockin ...

Programming HomeLink® (for U.S. owners)
The HomeLink® uniform transceiver in your vehicle has three buttons which tin can be programmed to operate iii different devices. Refer to the programming method below appropriate for the device. ...

Tire Identification Number (Tin)
The TIN may be found on ane or both sides of the tire, however, the engagement code may only exist on one side. Tires with white sidewalls will have the total TIN, including the date code, located on the ...

Source: https://www.m-sedan.com/jump_starting-2861.html

Share this post